Loading page
Loading
We build the hardware and install the system
Pole-mount battery
Distribution-network storage that goes on a single concrete pole instead of a plot of land: 40 kW / 96 kWh of LiFePO4 on a 400 V three-phase, four-wire connection, split between a battery cabinet and a PCS/control cabinet that bolt or strap to an existing pole. Integrated air-conditioning, IP55 enclosures hot-dip galvanised and painted for an exposed, polluted coastal atmosphere, and aerosol fire suppression with automatic battery isolation from the BMS. Four-quadrant P and Q control for peak shaving, Volt-VAr voltage support and absorbing solar PV to curb reverse power flow, controlled remotely over Modbus or DNP3 through Ethernet or the factory-fitted cellular modem.
The PDF carries the same figures as the specification below, in a form you can send to a designer or attach to a tender.
A quote starts with the site rather than the part number: the incoming supply, the loads that matter, and what has to stay on when the grid goes. Name BP10 in your message so the reply starts from this unit rather than the range — or email us about this unit and the code travels with the subject line.
Specification
Every value below is read from the published datasheet linked above. Where this page and the datasheet ever disagree, the datasheet is correct.
Specifications may change. The current datasheet carries the binding values.
The rest of the system
Pack and power electronics are supplied together as one unit, so there is nothing else to specify on the DC side. What the site still needs is the switchgear either side of the unit and the people to put it there.
Pairings are worked out from the published figures on both units — continuous discharge against rated power, the supply phases, and the interfaces they have in common. They are a starting point, not a sign-off: the final combination is confirmed against your incomer and your loads at design stage.
These are reference designs — the system we build for each kind of site, drawn and priced the same way we would draw yours. They are not client case studies: no customer is named on this site and no measured outcome is published against one.
BP10 is built by the same company that measures the incomer, draws the single line, carries the network operator application, installs the system and comes back to it. One accountable chain from cell to commissioning certificate, and one number to ring when something needs looking at.