Loading page
Loading
We build the hardware and install the system
Hybrid inverters
Three-phase hybrid inverter rated 10 kW continuous, with two independent MPPT inputs and battery management built in. Transfer from grid to backup completes in under 20 ms. Suited to three-phase homes and light commercial units where the load is spread across phases rather than stacked on one.
No datasheet is published for this unit. The specification below is the figure set we build and quote against — ask and we will send the engineering data behind it rather than a marketing sheet.
A quote starts with the site rather than the part number: the incoming supply, the loads that matter, and what has to stay on when the grid goes. Name IH10 in your message so the reply starts from this unit rather than the range — or email us about this unit and the code travels with the subject line.
Specification
These are the engineering figures we quote and build against. Test conditions, tolerances and the full datasheet are available on request — ask, and we will send what exists rather than a marketing sheet.
Specifications may change. Ask for the current engineering data before you design around a figure.
Same line, same discipline, a different size of problem. Single- and three-phase hybrids that hold solar, battery and grid on one supply and hand over fast enough that the house does not notice.
The rest of the system
A hybrid inverter without storage behind it can only follow the sun. The packs below can sustain at least the power this inverter is rated to move, so a full-power transfer to backup is not limited at the DC side.
Pairings are worked out from the published figures on both units — continuous discharge against rated power, the supply phases, and the interfaces they have in common. They are a starting point, not a sign-off: the final combination is confirmed against your incomer and your loads at design stage.
These are reference designs — the system we build for each kind of site, drawn and priced the same way we would draw yours. They are not client case studies: no customer is named on this site and no measured outcome is published against one.
IH10 is built by the same company that measures the incomer, draws the single line, carries the network operator application, installs the system and comes back to it. One accountable chain from cell to commissioning certificate, and one number to ring when something needs looking at.
